Welcome to the How to Craft Network

With Love - 02/27/2024

Main How to Image


Teal card blank 6 x 8"

Black/white cardstock


All Surfaces Foreign Romance 8 x 8" Paper Pad 

HD3D Happy Ever After Embossing Folder

Signature 3D Blossom Bunch Embossing Folder

Typewriter Tabs Washi Tape and Die

SBM Pigment Ink Pad: Cotton

SBM Dye Ink Pad: Magenta

Blending tool

WOW Heat Tool

SBM A3 Magnetic glass mat

Paper Trimmer


Double-sided adhesive tape

Die Cutting machine



How To Guide - Step 1

Trim this scenic paper from Foreign romance, to 7 1/4 x 5 1/4". 

How To Guide - Step 2

Position the Blossom Bunch embossing folder so the image goes down the right edge of the paper and run it through your machine. 

How To Guide - Step 3

Lightly blend the Magenta over the embossed areas and dry thoroughly with your heat tool. 

How To Guide - Step 4

Lightly "tap" the Cotton ink pad over areas of the embossed image and dry with heat tool, as pigment ink is slow drying and will smudge!!

Tear a vellum panel slightly wider than the Bride and Groom image on the Happy Ever After folder and 7 3/4" in length. Place inside the folder and run it through your machine.

Lay the embossed vellum down the left side of the embossed paper, fold the ends of the vellum over the edges and secure on the reverse with double-sided tape.  


How To Guide - Step 5

Mat your artwork on to black card measuring 7 1/2 x 5 1/2" and then onto the front of your teal card blank. Pop to one side. 

How To Guide - Step 6

Using the dies as a guide, cut ONE drop from the typewriter washi roll. Lift up the backing sheet along one end of the tape and adhere across the top of an A4 sheet of white card. Slowly peel away the backing, as you use your hand to smooth the washi tape down on to the card. Once the backing has been fully removed, you can burnish the washi to ensure there are no air bubbles or creases. 

How To Guide - Step 7

Line up the first die and secure with low tack tape before running it through your machine. 

How To Guide - Step 8

Line up the second die and run it through your machine. 

Pop out all the sentiments, pick out the one's you are using for this project and keep the rest in a tub for future projects.

How To Guide - Step 9

Finally, adhere your chosen washi sentiment tabs, with foam pads, to the bottom left of your card.