Welcome to the How to Craft Network

I Love You (card created by Sharon) - 02/27/2024

Main How to Image

Flutterbies  A5 die set

Thankful For You Lamination 

4” circle die

6 x 6” white cardstock

6 ½ “ x 6 1/2 “ black card layer

7 x 7 “ white card blank

Ink sprays: Cadence Yellow spray

Izink Rusty Saffron ink spray

Ink pads: Versafine black ink pad

SBM Sherbet & Bittersweet ink pad

Black cardstock 300gsm for die cutting




Eureka 101 

Die Cutting machine

How To Guide - Step 1

Die cut a circle in the centre of the 6 x 6” white cardstock, keeping the centre piece for later. 

How To Guide - Step 2

Spray the ink sprays on your aperture card, Place foam pads on the reverse and pop aside to dry. 

How To Guide - Step 3

Stamp the lamination butterfly on the white die cut circle, using the SBM inks as shown on the photo & stamp the sentiment in black. 

How To Guide - Step 4

Die cut TWO lots from the Flutterbies die, out the thick black cardstock, keeping a few of the butterflies for later. Glue on each side of the aperture leaving some overlapping in the centre. Cut off excess as required

How To Guide - Step 5

Glue the stamped circle topper into the centre of the 6 ½ “ x 6 ½ “ black cardstock.

How To Guide - Step 6

Adhere your artwork onto the black cardstock and then on to your card blank. Glue some of the butterflies onto the card to finish.