Faux Embossed Background Card with Gold Heat-Embossed Flower

A project from our live show Create Together Club - 5 Days of Creativity - Broadcast Tuesday 11TH Feb 2025 · 02/11/2025 · watch it from 14:15

Create a card with a dimensional embossed-look background by die-cutting leaf shapes from coloured card and layering them onto matching card stock. Add a heat-embossed gold poppy flower as a focal point, with layered stencil colouring and foliage accents, finished with a sentiment.

You will need

Stamps By Me 8.5 Inch Die Cutting & Embossing Machine - 170724ASEE IT

DOWNLOAD THIS GUIDE (PDF)

Step by step

1. Select two sheets of the same coloured card stock (teal was used here). ▶ watch 16:00
2. Place the die-cutting machine mat on a soft surface (not hard), then position your coloured card on top. ▶ watch 17:45
3. Arrange the leaf-shaped dies from your set onto the card, spacing them to avoid overlaps. ▶ watch 18:15
4. Run the layered card and dies through your die-cutting machine. ▶ watch 22:45
5. Remove the dies and carefully extract the cut leaf pieces from the card. ▶ watch 23:45
6. Glue the die-cut leaf pieces randomly onto the second sheet of matching coloured card to create dimension. ▶ watch 25:00
7. Trim the embossed background panel to your desired size using a trimmer. ▶ watch 30:00
8. Stamp the large poppy stamp onto white card stock using a sticky embossing ink pad. ▶ watch 36:30
9. Immediately pour gold embossing powder onto the wet stamped image, covering all inked areas. ▶ watch 39:00
10. Brush away excess powder with a dry brush, then heat-set the powder with a heat gun until it becomes shiny and fused. ▶ watch 39:45
11. Die-cut the heat-embossed flower using the coordinating poppy die and your die-cutting machine. ▶ watch 42:00
12. Use a layering stencil and blending brush with teal ink to add colour to the centre of the flower, leaving the outer petals white. ▶ watch 48:15
13. Die-cut additional foliage pieces from gold card stock to use as filler elements. ▶ watch 52:30
14. Adhere the embossed background panel to a white card base. ▶ watch 57:00
15. Position and glue the gold heat-embossed flower and foliage pieces onto the card, arranging them to avoid covering the embossed detail. ▶ watch 59:45
16. Stamp a sentiment (such as 'Many Thanks') onto white card stock using sticky embossing ink. ▶ watch 1:02:00

Tips from the show

• Always place a soft surface (such as scrap card) underneath your card when die-cutting, as dies need to cut into something forgiving rather than a hard surface.
• Cut multiple die-cut pieces at once when your machine is already out, so you can make several cards without repeatedly setting up.
• If you don't have foam pads in your stash, create them by layering and gluing thin strips of scrap card together.

Written up from the show itself. See every guide from our shows · free how-to guides · watch live on My Telly