Give your friends $10 off their first order!
Refer a FRIEND
A project from our live show CHRISTMAS WORKSHOP - Join Toni for her FREE project from the comfort of Studio 3 - Broadcast 7th Dec 22 · 12/07/2022 · watch it from 1:30
Create a stunning Christmas mini album featuring an innovative hinged spine system that allows pages to nest beautifully inside each other. This elegant project combines black cardstock structural elements with festive decorative papers featuring vintage Christmas music sheets and robin motifs. Master the professional technique of creating a hinged spine binding system for a polished, book-like finish.
Cut a piece of black cardstock measuring 6 inches tall by 4.5 inches wide for the spine cover.
▶ watch this step (4:45)
Score the black spine piece at 6 inches from the left edge, then turn it around and score 6 inches from the right edge to create fold lines.
▶ watch this step (6:30)
Fold along all the scored lines on your grey cardstock pieces to create hinges. These folded hinges will hold your album together.
▶ watch this step (8:00)
Cut a piece of black cardstock measuring 5.5 inches tall by 4 inches wide for the first interior page.
▶ watch this step (9:00)
Score the black card piece at 1 inch from each edge. Fold along the score lines to create hinges on both sides.
▶ watch this step (10:30)
Cut the next interior page from black cardstock to 5.5 inches tall by 3.5 inches wide. Score at 1 inch from each edge on the left and right sides, then fold along the score lines.
▶ watch this step (11:45)
Continue cutting additional cardstock pieces for the interior pages. Cut pieces measuring 5.5 inches tall, decreasing the width by half-inch increments: 3 inches wide, then 2.5 inches wide, and so on.
▶ watch this step (13:00)
Nest each scored and folded black card piece inside the previous one, leaving equal space on either side to create the hinged spine system for the album.
▶ watch this step (16:15)
Glue each nested black piece in place on the spine, ensuring the hinges are properly aligned and leaving equal spacing between each piece. The spine should look straight and even.
▶ watch this step (18:15)
Select a decorative paper from your kit and position it over the front cover. Hold it in place with one hand whilst smoothing it down to ensure good adhesion.
▶ watch this step (21:00)
Trim the sparkly paper to fit the cover edge using scissors. Optionally ink the edges with a dark ink pad for definition.
▶ watch this step (22:45)
Position the completed spine system centrally inside the front and back covers. Glue the spine system in place, ensuring it is evenly positioned between the two edges of the covers.
▶ watch this step (28:00)Written up from the show itself. See every guide from our shows · free how-to guides · watch live on My Telly