Interactive Pull-Out Tag Reveal Card

Take a piece of white cardstock and create a textured background using the scattered alphabet and circle elements from the stamp set in Distress Oxide Fired Brick ink.

Stamp the alphabet scatter elements across the top half of the card, overlapping slightly for detail.

Stamp the textured circle element multiple times along the same line to create a decorative border.

Mount the decorated white cardstock onto red cardstock, then mount both onto a white card base.

Heat emboss the typewriter stamp in gold onto white cardstock.

Colour the typewriter with alcohol markers in colours R16 and R1.

Cut a horizontal line through the typewriter image using a craft knife and ruler as a guide.

Use the Stamps by Me tag punch to create a decorative tag with notched top from cardstock.

Make the tag slightly narrower than the hole so it can slide in and out smoothly.

Stamp a sentiment onto the tag in black ink, positioning it below where the hole will hide it.

Apply foam pads around the hole opening on the back of the typewriter card to stop the tag from sliding too far.

Thread twine through the tag hole as an indicator that something can be pulled.

Apply washi tape around the edge of the typewriter to frame it and hide the mechanism.

Mount the entire typewriter assembly onto the decorated card base with foam pads for dimension.