Welcome to the How to Craft Network

Fabulous! - 06/19/2023

Main How to Image


White card blank 7 x7"

White card 5 1/2" square

White card A4

White card 6 x 4 1/2"

Watercolour Infinity Embossing Folder 

SBM Hybrid Ink Pad: Midnight

Distress Oxide: Victorian Velvet, Vintage Photo, Walnut Stain

Blending tool

All Surfaces Copper 8 x 8" paper pack

WOW Blooms Stamp And Die Collection

Let's Celebrate Stamp And Die Collection

Sepia Tabs Washi Tape and Die Collection

Circle Mask 2 1/2" diameter

Periwinkle sequins

Pick up gem and pokey tool

Water spray botlle

Eureka 101 Watercolour Tablet

SBM Magnetic glass mat

Paper Trimmer

Perfect Together Glue

Foam pads

Die Cutting machine


How To Guide - Step 1

Place your 2 1/2" circle stencil in the centre of the white card, cut to 5 1/2" square. 

If you don't have a stencil, die cut a circle from copy paper and use the aperture as your stencil. 

How To Guide - Step 2

Blend the Victorian Velvet within the stencil, fading out the colour as you move inwards. 

How To Guide - Step 3

Stamp a couple of the floral/foliage stamps in Midnight, from Let's Celebrate, around the stencilled circle. These will peek out from under your 3D floral elements, so think about their placement. 

How To Guide - Step 4

Place your artwork inside the Infinity embossing folder and run it through your die cutting machine. 

How To Guide - Step 5

Trim this metallic textured sheet, from the Copper paper pack, to 5 3/4" square. 

How To Guide - Step 6

Randomly stamp florals and foliage, in Midnight, around your 7" square card blank. 

How To Guide - Step 7

Adhere your embossed artwork on to the textured Copper paper and then on to your stamped card blank. 

Set to one side. 

How To Guide - Step 8

Ink up stamp 1, from the WOW Blooms, with Victorian Velvet on the florals and Vintage Photo on the foliage. Spritz with water and stamp on to the 6 x 4 1/2" white card.

Line up stamp 2, ink with Victorian Velvet and Walnut Stain, spritz and stamp.

Line up stamp 3, ink up with Walnut Stain, spritz and stamp and finally ink up stamp 4 with Walnut Stain, spritz and stamp. 

How To Guide - Step 9

Secure the coordinating die plate over your stamped images and run through your die cutting machine. 

How To Guide - Step 10

Adhere your 3D elements on to your card, as seen in the photo. Use both wet glue and foam pads to create depth and dimension. 

How To Guide - Step 11

Cut off one "drop" from your Sepia Tabs washi roll, peel up one end of the washi and adhere to the top of the A4 white cardstock. Gently peel off the backing as you stick the washi down and smooth out any air bubbles as you go. 

Use the die plates ONE at a time, to die cut the washi sentiments. 

Pick out your chosen sentiments and keep the rest in a tub for future projects. 

How To Guide - Step 12

Adhere the sentiments, with foam pads, to your card. 

How To Guide - Step 13

Finish off by adding a few sequins on, around and tucked just under your 3D elements.