Printed Thank You Sentiment Card with Stencilled Background

Un proyecto de nuestro programa en vivo PONTE AL DÍA con Simon en la LOCURA DEL LUNES, transmitido desde el estudio de HTCN el 15 nov 21 · 11/15/2021 · velo desde 2:45

A striking monochrome card featuring a printed repeating 'thank you' sentiment as the background, enhanced with stencilled starburst patterns in black and charcoal grey, and topped with a hand-coloured elephant character. The layered stencil technique creates depth and draws attention to the focal point.

Vas a necesitar

ALMOHADILLA DE TINTA A BASE DE COLORANTE IZINK 5 X 5CM - REGLISSE 050821iVERLO ALMOHADILLA DE TINTA PIGMENTADA IZINK 5 X 5CM - ROJO 060821xVERLO ALMOHADILLA DE TINTA VERSAFINE - ONYX BLACK - 300921cVERLO

DESCARGA ESTA GUÍA (PDF)

Paso a paso

1. Print a full page of 'thank you' sentiment onto cardstock using your computer printer. ▶ watch 3:00
2. Trim the printed page to 6.5 by 5 inches using a paper trimmer to fit your card blank. ▶ watch 3:15
3. Place a starburst stencil in the bottom corner of the printed panel and lightly tap black ink through it using a circular motion. ▶ watch 4:45
4. Apply the stencil again in the same corner with darker, heavier pressure to create a two-tone effect with charcoal grey and black. ▶ watch 6:00
5. Reposition the stencil to the top corner and repeat the light and dark tapping technique to create a secondary focal point. ▶ watch 7:00
6. Edge the card with red ink by dragging the ink pad along all four edges to soften the harshness and introduce colour. ▶ watch 8:15
7. Adhere the printed and stencilled panel to your card blank using double-sided tape. ▶ watch 9:00
8. Stamp the elephant character onto separate cardstock using black ink and a stamping block. ▶ watch 9:45
9. Colour the stamped elephant with watercolour techniques, adding grey to the body, red to the ears and cheeks, and darker black to the trunk and details. ▶ watch 10:30
10. Heat-set the coloured elephant with a heat gun to prevent smudging during die-cutting. ▶ watch 12:30
11. Die-cut the coloured elephant using the complementary die to create a crisp outline. ▶ watch 12:45
12. Mount the die-cut elephant onto the card using foam pads to raise it above the surface. ▶ watch 14:15
13. Add decorative heart stickers around the card to break up the background and tie the design together. ▶ watch 14:45

Consejos del programa

• You can personalise the card by adding someone's name to the printed sentiment instead of 'thank you'.
• If you don't have heart stickers, you can use red glitter or stickles as an alternative embellishment.
• Lightly tap the stencil first before applying heavier pressure to build up the colour gradually and avoid over-inking.

Más de este programa

• Rolled Edge Card with Layered Sentiments and Elephant Character

Redactado a partir del propio programa. Mira todas las guías de nuestros programas · guías paso a paso gratis · mira en vivo en My Telly