Good Luck Card with Edge-Cut Detail

Take a DL card base and position the outline die so it hangs half off the edge of the card.

Place your cutting plates on top of the die, ensuring they only cover the portion of the die that is on the card.

Run the card and die through your cutting machine to cut the edge detail.

Remove the card carefully and use scissors to cut along the marked line created by the plates to complete the edge.

Stamp the floral image onto white cardstock using blue ink.

Run the stamped image through the cutting machine with the coordinating outline die to cut around the design.

Stamp the sentiment 'Good Luck' onto black cardstock.

Run the sentiment through the cutting machine with the coordinating die to cut around the words.

Glue the patterned paper panel down the side of your edge-cut card base.

Attach the stamped and die-cut floral image to the card using foam pads for dimension.

Attach the die-cut sentiment below the floral image.

Add sparkle or glitter to the flower petals using glue and glitter for a finishing touch.