Melted Powder Ring

Prepare your foil tray by squeezing it gently to create a spout on one side and attaching a peg to the opposite side for holding.

Measure out a couple of teaspoons of melted powder into a metal spoon.

Add your chosen embossing powder colour to the melted powder and mix thoroughly until the colour appears to disappear into the powder.

Heat the spoon from underneath using your heat tool on setting two, holding it about an inch away until the mixture starts to melt.

Once melted, place your heat tool on top of the spoon to keep the mixture molten, then tip it into the pouring spout of your prepared tray.

Insert your ring base into the molten mixture, holding it steady with your hand.

Allow to set for a few minutes, then gently wiggle the peg to release the ring.

Allow to cool completely before removing from the peg or wearing, as the metal will be very hot.