Embossed Sparkly Lamination Flower Card

Cut your teal cardstock to the desired size and position it on your work surface where you want to place the stamped image.

Use an anti-static bag to dust the cardstock, removing any moisture or static before embossing.

Apply sticky embossing ink pad to the first part of the lamination stamp.

Stamp the inked stamp onto the cardstock, pressing firmly to ensure a clear impression.

Stamp the image a second time onto the same area to ensure all the detail is captured clearly and completely.

Sprinkle burnt orange and white sparkly embossing powder over the wet ink on your stamped image.

Tap off excess embossing powder onto a card blank or piece of card to catch it for reuse.

Heat set the embossing powder with a heat gun, moving quickly to avoid over-heating and buckling the card.

Position the second detail stamp part over the first layer, carefully aligning the eye and mouth sections to match the initial stamped image.

Apply sticky embossing ink to the second stamp and stamp onto the card.

Sprinkle purple and green sparkly embossing powder over the stamped layer, ensuring good coverage of the wet embossing ink.

Heat set this layer with the heat gun to ensure the embossing powder is fully melted and set.

Apply sticky embossing ink to the final detail stamp and position it carefully over the previous stamped layers on your card.

Sprinkle cream sparkle embossing powder generously over the stamped image on the final layer, ensuring complete coverage of the wet embossing ink.

Heat set the final layer with the heat gun until the powder fully melts and sets.